Note - May 2009 - This only applies to BAPS file system. Newer Atcoms no longer ship with this version.

When upgrading from an existing version 1 GUI we have found the following to be the best method.

note:backup any configuration files that you require. Version 2 GUI requires a later version of asterisk to function

Run "ipkg list_installed" to check which packages are installed on your ip0x. Then run "ipkg remove" to uninstall the following

Run "ipkg update" to retrieve a list of available packages

Run "ipkg install" to install the following

• asterisk-spandsp-1.4.21.2 (for caller ID)
• asterisk-gui
• zaptel-sport - (zaptel-ip01 for IP01)
• native-sounds
• network-static (Without this the device defaults to DHCP and I've had issues getting the IP01 to pick up an address)

root~> /etc/init.d/network disable
root~> /etc/init.d/network-static enable
root~> reboot

To change the static IP settings edit /etc/init.d/network-static 

If you change tone setting on the hardware config page e.g. to uk, then zaptel fails due to the software writing duplicate entries e.g. fxsks=1 into zaptel.conf. Removing these entries doesn't appear to resolve the issue. The best method to date is to use vi and edit the file directly.

To perform this process:

• root:> cd /etc
• root:>vi zaptel.conf

For UK settings amend as detailed below:

loadzone = uk
defaultzone=uk

reboot

The hardware config page in the GUI will now display UK tone.