The Digium TE405P maximises performance and scalability through bus mastering architecture. Supporting both E1 and T1 environments, the TE405P is selectable on a per-port or per-card basis. This enables signaling translation between E1 and T1 equipment and allows cost-efficient T1 channel banks to connect with E1 circuits. The Digium TE405P improves I/O speed by up to 10 times - resulting in reduced CPU load and increased card density per server.

Digium has designed the TE405P to be fully compatible with existing software applications and fully Asterisk integrated. The open source driver also supports an API interface for custom application development.

The TE405P supports industry standard data and telephony protocols, including Primary Rate ISDN (both North American and Standard Euro) protocol families for voice, PPP, Cisco, HDLC, and Frame Relay data modes. Both line-side and trunk-side interfaces are supported, also included are advanced call features.

The TE405P is for use only with a 5.0 volt PCI slot. The TE410P is for use only with a 3.3 volt PCI slot - typically available on newer motherboards and in 64-bit PCI bus architectures.

Data Modes:

• Cisco HDLC
• HDLC
• PPP
• Multilink PPP
• Frame Relay

Voice Modes:

PRI CPE & PRI NET

• NI1
• NI2
• EuroISDN
• 4ESS (AT&T)
• 5ESS (Lucent)
• DMS100

E&M

• Wink
• Feature Group B
• Feature Group D

FXO & FXS

• Ground Start
• Loop Start
• Loop Start with Disconnect Detect

Certifications:

• Telecom: FCC Part 68 (TIA-968-A), IC CS-03, TBR 4, TBR 12, TBR 13, AS/ACIF S038, AS/ACIF S016
• Safety: UL/CSA 60950, IEC 60950, EN60950, AS/NZS 60950