The Digium TE210P is the next generation of hardware that improves performance and scalability through bus mastering architecture. Both E1 and T1/J1 environments are supported on the TE210P - selectable on a per-card or per-port basis. This enables signaling translation between E1 and T1/J1 equipment and allows inexpensive T1/J1 channel banks to connect with E1 circuits. Because the TE205P improves I/O speed over slave-only architecture, the result is reduced CPU usage and increased card density per server.

The Digium TE210P has been designed to be fully compatible with existing software applications and is fully integrated with the open-source Asterisk PBX/IVR platform. In addition, the open source driver supports an API interface for custom application development. Using Digium hardware and Asterisk, numerous combinations of telephony configurations are possible. From the traditional PBX to VoIP Gateways, Digium solutions are paving the way for a new generation of worldwide communications.

The TE210P supports industry standard telephony and data protocols, including Primary Rate ISDN (both N. American and Standard Euro) protocol families for voice, PPP, Cisco, HDLC, and Frame Relay data modes. Both line-side and trunk-side interfaces are supported, also included are advanced call features. The TE205P is for use only with a 5.0-volt PCI slot. The TE210P is for use only with a 3.3-volt PCI slot.

Data Modes:

• Cisco HDLC
• HDLC
• PPP
• Multilink PPP
• Frame Relay

Voice Modes:

PRI CPE & PRI NET

• NI1
• NI2
• EuroISDN
• 4ESS (AT&T)
• 5ESS (Lucent)
• DMS100

E&M

• Wink
• Feature Group B
• Feature Group D

FXO & FXS

• Ground Start
• Loop Start
• Loop Start with Disconnect Detect